Hi Hats

Learn how to correctly record Hi-Hats.

The hi-hat is a fundamental component of the main rhythm section, producing sharp, high-frequency transients that drive the tempo and groove of a song.

Microphone Type

Both dynamic and small-diaphragm condenser microphones can be used depending on the desired tonal brightness:

  • Dynamic Microphone (Focused & Punchy)
    • Polar Response: Cardioid or Supercardioid
    • Example: Shure SM57, Shure KSM8
  • Small-Diaphragm Condenser (Bright & Detailed)
    • Polar Response: Cardioid or Hypercardioid
    • Example: AKG C451, Neumann KM184

Technique

Position the microphone above the hi-hat, pointing downward at a distance of 5 cm to 25 cm. Angle the capsule slightly toward the outer edge where the drummer's stick strikes the top cymbal to capture maximum stick definition and articulation.

To prevent excessive snare bleed, position the hi-hat microphone so the physical body of the hi-hat cymbals acts as a shield between the capsule and the snare drum, blocking direct sound from the snare shell.

Top Tips

  • Avoid Air Blasts: Do not aim the capsule directly at the edge gap where the two cymbals meet. The rapid opening and closing of the hi-hat produces gusts of air that cause low-end wind pop and capsule distortion.
  • Choosing Microphone Tone: Dynamic microphones produce a grittier, punchier, and controlled sound, whereas small-diaphragm condensers yield a bright, detailed, and pristine top end.
  • Relying on Overheads: In many rock and pop mixes, dedicated hi-hat microphones may be unnecessary if the overhead microphones capture sufficient hi-hat level and detail with good stereo positioning.

Engaging a steep high-pass filter (around 200 Hz to 300 Hz) on your hi-hat channel removes unwanted kick and floor tom bleed without affecting the hi-hat's crisp high frequencies.