Equalization Techniques
Discover the power of an equalizer for enhancing sound quality, refining audio balance, and crafting the perfect mix.
Equalizers are powerful tools in audio production, commonly used to:
Correct Problems in a Recording
An equalizer can help remedy imperfections in recordings, such as unwanted noise or issues with sound pickup. It’s best to capture a clean recording from the start, rather than relying on EQ to fix problems during mixing.
Tips to consider during, and after a recording include:
- High-Pass Filters: Switch on high-pass filters to eliminate low rumbles from sources like local traffic.
/mixing/techniques/equalization-techniques
- Low-Pass Filters: Use low-pass filters to cut high-frequency noise, such as air conditioner hum or background hiss.
- Frequency Roll-Off: For bass-heavy instruments, filter out frequencies above 8 kHz to reduce noise without impacting audible sound.
- Proximity Effect: Be cautious of added bass energy when miking close to drums. If the bass becomes overwhelming, apply a low-frequency roll-off.
Improve Instrument Clarity
Equalization can help enhance an instruments sound.
Harmonic and Fundamental Frequency Rules
- Boosting the harmonics of a sound gives the impression of more presence and brightness
- Decreasing the harmonics of a sound gives the impression of a dull, less dazzling sound
- Boosting a sound around its first fundamental frequency will promote warmth and depth
- Decreasing a sound around its fundamental frequency will promote a colder, less powerful sound.
Muddiness
The muddy area is focused between 100 - 500 Hz. Muddiness normally comes from bass-heavy instruments, such as the kick drum, bass guitar, and the lower end of the piano.
To reduce muddiness, scan the lower frequencies with a high Q value and a moderate boost level of about 8dB. Once excess muddiness is identified, cut the signal right down, and then slowly bring up the gain control until there is a good balance between body and muddiness.
If too much bass is lost from a sound, try adding some moderate boost to the sub-bass region at around 60 Hz to compensate.
Exercise caution when cutting frequencies and do not cut the same frequency on all of the sounds.
Honk
The honk area is focused between 500 - 3000 Hz and determines how prominent an instrument is in the mix. Excess output at this range can sound cheap, boxy and can cause unwanted ear fatigue. If boosting in this area, be very cautious, especially on vocals. Human hearing is extremely sensitive at these frequencies with the slightest boost or cut resulting in a huge change in the sound.
- If there are any 'irritating' frequencies, sweep through the sound with a medium curve at about 10dB cut. Once the frequencies are located, adjust the amount of cut as desired.It may be necessary to compensate for any cutting in this area by applying a small amount of boost around the 5-8 kHz area to liven up anything that may have been severely affected by the cutting. This will help to preserve the overall brightness.
When applying equalization, it is advisable to use large amounts of cut or boost initially. This helps give a better idea of the frequencies being affected. The human ear can quickly become used to an equalized sound, so quick successive bursts on the gain knob until the frequency sounds about right is best.
Create Room and Balance
The equalizer can be useful for creating space in the mix by balancing frequencies. If certain instruments occupy a similar frequency band they will mask each other within that particular area of the audio spectrum, often resulting in a muddy sound.
To allow elements to best fit together, there has to be some juggling of frequencies so that each instrument has its own predominant frequency range.
If a kick drum is heavy and powerful in the 80 Hz but getting muddied up by the bassline, cutting the bassline around this frequency will free up valuable mix room allowing for the kick to shine through.