Snare
Learn how to correctly record a snare.
Microphone Type
When miking a snare drum, dynamic microphones are the most common choice due to their durability and high SPL handling, though small-diaphragm condensers can also be used for extra high-end crack:
-
Dynamic Microphone (Standard Choice)
- Polar Response: Cardioid or Supercardioid
- Example: Shure SM57, Audix i5
-
Small-Diaphragm Condenser (Alternative / Bottom Mic)
- Polar Response: Cardioid
- Example: AKG C451
Technique
Position the microphone so the capsule is roughly 2 cm to 6 cm above the top head, aiming inward from the outer rim at a 45-degree angle.
Because the snare is surrounded by the hi-hat and rack toms, precise angling is essential to isolate the snare signal. Angle the rear dead-spot of the microphone directly toward the hi-hat to minimize high-hat bleed onto the snare track.
Top Tips
- Protect the Capsule: Always position the microphone slightly behind the rim, outside the drummer's primary stick strike path to prevent accidental hits.
- Targeting Attack: Aiming the capsule closer toward the center of the head increases stick attack and impact, while pointing it closer to the rim increases ring and overtones.
- Key Frequencies: A snare drum's crisp attack energy and crack reside in the 4 kHz to 6 kHz frequency range.
- Controlling Hi-Hat Bleed: If hi-hat leakage remains excessive, switch to a supercardioid microphone to utilize its tighter frontal pickup angle and side null points.
- Damping Overtones: Eliminate unwanted metallic ringing or sustain using clip-on dampening rings, Moongel, or small strips of gaffer tape.
- Top and Bottom Dual Miking: To capture maximum snap and rattle, pair the top mic with an additional microphone placed beneath the snare drum, pointed directly up at the snare wires. Because the top and bottom capsules face opposite directions, you must reverse the polarity (flip the phase) on the bottom channel to achieve a full, punchy tone.
Inverting the phase on a snare bottom microphone is critical. Always flip the phase switch while listening to the top and bottom channels summed together—the correct setting will instantly yield a thicker low end and cohesive snap.